Bio Waste Storage & Removal
Tiger has the storage tanks available to store and dispose of bio waste from Coronavirus field hospitals and testing stations. Below are specs of just a few tanks that you can choose from. Give us a call and we will help you select the right container for your specific requirements.
SPECIFICATIONS |
\
|
500 BBL STORAGE TANKS
- FLOOR - 1/4 PL, 4" V-bottom with integral formed side channels
- FLOOR SUPPORT - 10" channel longitudinal runners with formed 1/4 PL crossmembers
- WALLS - 1/4 PL solid welded, corrugated steel, corrugations 15” on center
- ROOF - Flat top, 1/4 PL solid welded with channel supports outside
- FRONT/REAR - 1/4 PL solid welded, corrugated steel, 10” radius at vertical outside corners
- DRAIN/FILL - 4" floor drain at rear end, 3" fill pipe to roof at rear, 4" suction line connection at front to sump, 8" flanged front manifold connection with turn down to floor. 8” exterior manifold with 4 – 4” couplings and plugs, hammer union sub, nut, and cap on ends
- GEL LINE - 4" mid high connection on curb side, 4” internal pipe with 3/4” holes located on 12” centers towards floor center, capped on rear end (ends near side manway)
- MANWAY - 21" manway on front and side, 2 – nonsealed hatches on roof
- PICK UP - Standard 5th wheel king pin
- WELDS - All welds continuous except substructure crossmembers
ROLL-OFF BOXES
- FLOOR: 3/16 PL one piece
- CROSSMEMBERS: 3 x 4.1 channel 16” on center
- WALLS: 3/16 PL one piece with tubing top rail, inside liner hooks
- DOOR: 3/16 PL with tubing frame
- FRONT: 3/16 PL slant formed
- PICK UP: Standard cable with 2 x 6 x 1/4 rails, gusset at each crossmember
- WHEELS: 4 each 10 DIA x 9 long with grease fi ttings
- DOOR LATCH: 4 independent ratchet binders with chains, vertical second latch
- GASKETS: Extruded rubber seal with metal retainers
- WELDS: All welds continuous except substructure crossmembers
- FINISH: Coated inside and out with direct to metal, rust inhibiting acrylic
enamel color coat
- HYDROTESTING: Full capacity static test
- DIMENSIONS: 22’-11” long (21’8” inside), 99” wide (88” inside), see drawing for height
- OPTIONS: Steel grit blast and special paint, Ampliroll, Heil and Dino pick up
- ROOF: 3/16 Pl roof panels with tubing and channel support frame
- LIDS: 2 - 68” X 90” metal rolling lids spring loaded, self raising
- ROLLERS: 4” V-grove rollers with delrin bearings and grease fi ttings
- OPENING: 2 - 60” X 82” openings with 8” divider centered on container
- LATCH: 2 independent ratchet binders with chains per lid
- GASKETS: Extruded rubber seal with metal retainers
|
